• Maximum cutting length 450 mm or 900 mm (with straight cut and depending on cutting machine type).
• Material is passing through with grain side up.
• Unwind station for rolls up to ø700 mm and a roll width of 310 mm or 610 mm (depending on type).
• Automatic feeding and measuring system.
  Minimum cutting length
  Cutting machine type SGW = 100 mm
  Cutting machine type WSQ = 150 mm.
• Guillotine cutting system or crush cut system for straight cut and/or wave cut with wave form type 20800.
• The machine consists of an unwind station, a feeding and measuring system as well as a cutting machine.

• Unwind station for rolls up to ø700 mm and a roll width of 310 mm or 610 mm (depending on type).
• Automatic brake control type AV.
• Pneumatically expandable unwind shaft for cores with ø75 mm.

Options:

• Automatic edge guiding system – especially recommended for wave cuts.
• Second unwind station for double layered cutting (depending on material).

• Automatic feeding and measuring system (the material will be fed, not pulled).
• Minimum cutting length of 100 mm with type SGW or 150 mm with type WSQ (the material must be as flat as possible).
• Measuring accuracy approx. 1 mm or 0.1 % of the length.
• Digital setting of length and number of cuts.
• If bad material appears, the automatic operation can be stopped and the counting continues after the problem is solved.

• For different joint directions (for example type AL and arrangement “R-4”.
• Cutting angle adjustable between 90° and 45°.
• Guillotine cutting machine type SGW
  – for straight cut (standard) or wave cut (optional).
• Crush cut cutting machine type WSQ
  – for straight cut or wave cut
  – especially also suitable for non-woven material.
• Maximum cutting length 450 mm or 900 mm (with straight cut and depending on the cutting machine type).
• No stacking device.
• Further information can be found on the separate flyer for knives, knife holders and fixed knife sets.

Options:

• Blade holder and blades for wave form (for cut-to-length machine type SGW).

Joint directions type AL and AR seen from the grain side. Recommended: type AL

• Blade holder and blades for wave form (for cutting machine type SGW).
• Automatic edge guiding system – especially recommended for wave cuts.
• Second unwind station for double layered cutting (depending on material).