• The discs are produced directly from rolls.
• For discs with a maximum diameter up to 225 mm as well as for several other punching designs (according to customer specification).
• Maximum roll width 320 mm.
• Maximum roll diameter 600 mm.
• Crush cut system.
• Maximum cutting force 250 kN (25 t), continuously adjustable.
• Punching performance approx. 16-20 discs/minute with single-layer punching and with single tool (depending on feeding length, disc diameter and material).
  Up to 3 times higher with multi tool and multi-layer punching.
• Adjustable penetration depth of the blades (steps of 0.05 mm).
• Adjustable feeding system 80 … 300 mm.
• Counting automatic
  (endless counting up or counting down with automatic stop).

• Unwind station for rolls up to ø600 mm and a maximum width up to 320 mm.
• More than one unwind station for double-layered production available on request.
• Adjustable feeding system 80 … 300 mm.
• Unwinding with fixed shaft and 2 board discs.
• Two-hand control for safety reasons during setup of the machine as well as for the adjustment of the punching tools (cutting depth and cutting pressure).

Options:

• More than one unwind station for double-layered production.

• Crush cut system.
• For discs with a maximum diameter up to 225 mm as well as for several other punching designs (customer-specific designs on request).
• Punching performance approx. 16-20 discs/minute with single-layer punching and with single tool (depending on feeding length, disc diameter and material).
  Up to 3 times higher with multi tool and multi-layer punching.
• Maximum cutting force 250 kN (25 t), continuously adjustable.
• Adjustable penetration depth of the blades (steps of 0.05 mm).
• Easy changeable punching tool and punching support.
• Double punching tool (available on request)
  for simultaneous punching of two discs (for disc diameters <=150 mm).
• Automatic rotation of the punching support to reduce wear.
• Counting automatic
  (endless counting up or counting down with automatic stop).

Options:

• Double punching tool
  for the simultaneous punching of two discs (for disc diameters <=150 mm).
• Punching tool according customer-specific design.
• Punching tool holder
  depending on the desired punching design, more than one holders are needed.

• Collecting tray for the punched discs.
• Ejector cylinder for pushing the punched material into the collecting tray.
• Collecting tray with removable drawer for punching waste like center holes, suction holes etc.

• More than one unwind station for double-layered production.
• Double punching tool
  for the simultaneous punching of two discs (for disc diameters <=150 mm).
• Punching tool according customer-specific designs.
• Punching tool holder
  depending on the desired punching design, more than one holders are needed.